Mirrored Tiny House Concept

Call me crazy, but I really like the idea of a mirrored tiny house; but I have a lot of questions about the feasibility. What would it be like to have a mirrored tiny house? Would it blend into its surroundings or stand-out like a soar thumb? Would birds crash into it? Would it cost a fortune? Would the occupants get constantly photographed by curious onlookers?

This design is a simple box with a 3/12 gable roof and a slightly more aerodynamic nose than most tiny houses. The boxy shape would likely be easier to cover with mirrors. The nose and roof would be black metal roofing for durability. The roof would be covered in solar panels on mounts that tilt to the left and right.

As you can see in these renderings the mirrors reflect the surrounding scenery nicely – much like the real photos of mirrored houses we’ve seen on the Internet. I actually think the house might just blend into the natural surroundings once parked. On the road, I bet it would be quite the eye catcher – hopefully not a distraction or difficult to see. For sure it would be a huge conversation starter and photographer magnet.

This tiny house design is 36-feet long on a custom trailer design with tandem dual wheel axles. The rear section of the trailer is higher to provide more space for water tanks (fresh, black and grey) under the floors of the kitchen and bathroom.

The home’s shutters would be mounted on heavy duty self-opening spring hinges or normal hinges with gas struts for support. It would be super cool to have them on automatic opening gas struts like those found on the hatch of an SUV.

When on the road the house closes-up to keep things safe and aerodynamic. You could also close the house up when in camp to help secure it from would-be thieves. The nose of the house is angled and protrudes over the trailer tongue to provide space for utility gear and an aerodynamic nose into the wind.

A television, stereo, and minisplit A/C head are hidden away behind the folded-up table. The minisplit would not be functional with the table up, and is hidden above the stereo behind the wood slats. There are three other minisplit head location shown in the floor plan at the bottom of the story.

The sofas are on castor wheels and can be rolled together to form a bed. The bed can be centered off to one side. The sofas have three storage drawers each to provide clothing storage. The shutters or roll-up blinds could be closed for privacy at night.

The bunk bed length is over seven feet. Bed width is over three feet, so standard twin mattress could fit in each bunk. Simple sliding doors shut when privacy is needed. Opening windows in the bunks provide light, ventilation, and egress in an emergency. A small loveseat sized sofa and a fold-up desk provide more function to the bunk room.

The bathroom is accessed from a hall that separates the kitchen from the bunk room. A swinging door would be used for the bathroom so towels could be hung to dry on a towel bar on the door. Across the hallway from the bathroom is ample storage and full height closets for four people.

Pocket doors separate the bunk room from the hallway and bathroom, and the bathroom and hallway from the kitchen. The kitchen and living room stay open to each other. There is no loft in order to keep the ground clearance of the trailer high and the roofline under 13-feet so the house could be taken on an Alaskan or Canadian ferry adventure.

This is a tiny house designed to travel with a family of four. It’s off-grid setup could be configured to be large enough to keep it cool in Arizona or warm in Alaska. A backup propane powered generator could be mounted in the nose to provide extra power on dark says. There’s plenty of space for large RV water and grey & black tanks so that you can stay for a week or two at a time in off-grid boondocking campsites.

I think the best mirrored material for the exterior would be mirrored polycarbonate, but it is very expensive and I’m not sure about its durability. Polished stainless steel would be much more durable, but if it is not perfectly flat a funhouse mirror effect seems to occur. Glass probably provides the best mirror surface, but would likely be the most expensive and would be more susceptible to breakage than polycarbonate. One thing is for sure, the owner of a mirrored tiny house would be washing it all the time to keep it shiny and clean.

Mirroring aside… I really like this floor plan. I think it would be ideal for a traveling family. The parents would use the living room as their bedroom at night and the kids (even teenagers) could be comfortable in the bunk room at night.

What do you think about this design? What do you think of a mirrored tiny house?